BACK TO UNIT SELECTION

WIRING DETAILS FOR KTX2 HARNESS
Please fill in the form below as accurately as possible and submit. Lengths are in centimetres.
Any functions not required, please enter 'none' or 'n/a'.
We will review the details provided and if there are any questions, we will get in touch.

Thu Dec 9 07:21:06 2021
NAME: PHONE: 
EMAIL: INVOICE: 
AIRCRAFT REG & TYPE: 

The TQ KTX2 is a single piece transponder that sits in the panel.  All wiring should be measured from where the main body will be mounted allowing sufficient length for routing around the airframe and securing the wires into place.
POWER: cm KTX2 to circuit breaker/fuse.
GROUND: cm KTX2 to ground block.
RS-232: cm KTX2 to serial device. (GPS/EFIS)
SUPPRESSION IN: cm KTX2 to suppression input.
SUPPRESSION OUT: cm KTX2 to suppression output.
SQUAT SWITCH: cm KTX2 to squat switch
ANTENNA CABLE: cm KTX2 to antenna (BNC-BNC)
ANY OTHER NOTES: